Finishing the RoboGlyphs Project

Posted by Erin, the RobotGrrl on Saturday, June 12th, 2010

Just the fun stuff was left for this project! Here is a photo blog montage of the journey to the finish

The first thing to do was to put the black foam backing onto the RoboGlyph. I wasn’t really sure how the glue would look, so I placed a minimal amount on the corners. Next time I do this, I’m going to put glue all over the back since it created a neat effect with the sparkles on the foam. It sort of makes them more sparkly…

Cut the excess foam away with the Xacto knife. Cutting it on a slight inwards angle towards the glyph is much better than a 90 degree cut, I found.

To mount the RoboGlyphs to their board, I used toothpicks on the back. This is what it looks like from the front:

Zoomed in:

The toothpicks fit nicely in the holes of the perf board. I found that if you put glue in the perfboard hole, then put the toothpick in, it will stick better.

They’re all tilted forward because they don’t have a proper footing yet! =)

Again, from the back:

At first I was thinking about using some rubber feet to keep the RoboGlyphs standing, but I didn’t have any on hand. The next best thing: Lego! Plus, there is something else that I can add on to the Lego to make it even more interesting…

The “more interesting” part would be tinfoil! Tinfoil is a conductor, and therefore can have a charge running through it.

It’s quite a difficult task to manage to put the tinfoil onto the Lego bricks. This try was using hot glue. When another brick is placed on this one, the tinfoil splits.

I tried using a simple glue stick, and it actually works much better! The tinfoil does not split when another brick is placed on top of it.

Putting tinfoil inside the brick is much easier.

While the glue is setting for the tinfoil, it’s time to wire up the RoboGlyphs. Thanks to the super simple colour coded wires, the process took a matter of seconds. The Sanguino only has 6 PWM pins, and there are no PWM drivers in my pocket, so the green LEDs will not be controlled by PWM.

Green is probably the best default colour!

Red:

Blue:

The edge lighting is really cool, even though I didn’t really do it very precisely. You can’t really tell from this photograph, though.

The Lego 2x4s were glued on to the bottom of the boards. Then they’re placed onto the tinfoil-coated Lego brick. 5V is applied through an alligator clip!

The other end goes into an Analog In, where the Sanguino checks to see if there’s anything there. If nothing is there… The lights don’t turn on!

There’s a few finishing touches that I have to make. I’d like to connect it to Twitter via Processing, and have it as a permanent setup. I also have to fix the Lego connections, as right now it can only tell if the middle RoboGlyph is disconnected! =)

Posted in: Art, Projects.
Tags: foam, glue, LED, Lego, perf board, RGB, RoboGlyphs, sparkle, Tinfoil, toothpick

Leave a Reply

Name (required)

Mail (will not be published) (required)

Website