RBBBs and Pololu SSCs

Posted by Erin, the RobotGrrl on Tuesday, August 5th, 2008

I received the two RBBB’s, 1 FTDI TTL USB cable, and two Pololu Serial Servo Controllers (SSC) I bought a few weeks ago. Since then… I’ve been tinkering with them quite a bunch. I learned an incredible amount too from just a tiny board!

Building up the RBBB wasn’t too hard. At first, I printed off the wrong ‘instructions’ – which mind boggled me a bit until I noticed that they were indeed wrong. Once I had the right instructions printed… it was more simple. I was worried about the polarity of the bigger capacitors. After I had it all finished… I went and looked up the FTDI-USB cable specs. This cable is pretty interesting if you think about it, 1 wire turns into 6 more colourful wires -Gnd, CTS (clear to send), +5V, TX, RX, RTS (request to send). I downloaded the Blink program without any problems… until I wanted to test it. The LED wasn’t blinking! After about 5 minutes of intense thought, I realized that there was no LED on pin 13. That was a stupid mistake!

Another stupid mistake, but this one is funnier, was when I was trying to test the other RBBB.
… I forgot to put the chip into the IC socket. That really made me ‘lol’ for 10 minutes.

Then, I was trying to fit it into the breadboard… lets just say it took a longer than normal time.

When the Pololu SSCs showed up, I was pretty excited! Then when I saw them… they are REALLY tiny! It was a big challenge to solder these without them flying out of my hand. I don’t have a 3rd hand tool to hold it steady, so I would sometimes have to hold the ‘pinchy-things’ with my elbow and hold the solder and soldering iron with my hands. The headers were extremely difficult too…

Getting the Pololu to work with the Arduino is pretty aggrivating. I think I’m almost there, I just have to switch the input to the logic level side as I was using the RS-232 one. I thought that the Arduino used RS-232 on its TX line, but it doesn’t. It uses a non-inverted logic level (er well, that’s at least what I read). Tomorrow I plan on looking up the difference between the two

Here are some pictures… I finally threw the desoldering pump out the window (joking) and bought solder wick. Also finally bought NON-LEAD SOLDER!

Other than playing with these, I’ve been flow-charting A LOT of AI programs, and learning more first-order predicate logic. I really like logic and the probabilities and Bayes and everything!!!!! Also having fun thinking about random and bell curves… More back-dated Stanford blog posts to come (so many photos hahah)!

Posted in: Programming, Projects, Robot.
Tags: Arduino, controller, FTDI, IC, Pololu, RBBB, serial, serial servo controller, servo, soldering, TTL

One Response to “RBBBs and Pololu SSCs”

1. Ron Says:
   August 7th, 2008 at 1:56 PM

   A good investment would be some Panavise equipment. They sell a Panavise Jr (Model 201) for about $20 US–a good inexpensive one for getting started. If it tips over, just screw it to a board. They also make a wide range of PCB holders, bases, etc. Their Multi-Purpose Work Center – Model 350 is great. Most everything is interchangable (swap out bases, mounts, etc) so their stuff is a great long-term investment.

   In general, good tools are a wise thing to spend money on. A good tool will save you a LOT of time and annoyance. Plus, a solid tool will last a lifetime.

Leave a Reply